Mix Repairs

Most Common Siemens Washing Machine Error Codes Guide

Siemens logo

Siemens error codes for your washing machine don’t always follow a simple numerological sequence and can sometimes appear quite unusual. However, with a little understanding of how they work, you’ll be able to see what they mean and where the problem may lie, even if you can’t fix it yourself.


Siemens washing machine error codes

Siemens washing machine fault codes can be divided into category errors:

Communication error

Error 10 or F10

This error indicates that your washing machine has found a problem with the internal communication in your appliance. Typically this will be a wiring or electrical problem between the motor and the module.

Door lock errors

Error 06, 16, and 34

These error codes relate to the door not closing properly and could be due to a faulty door latch or catch. An electrical door lock may be a more complex issue with wiring or power supply issues.

Drainage errors

Error 03 and 18/ F03 and F18

Siemens washing machine error code F18 and error code F03 means that your washing machine can’t drain properly which is often caused by an obstruction in the filter, drain hose or drain pump. The drain pump itself may be faulty and need replacing.

Heater errors

Error 02 and 09

Error code 02 signifies that there’s an issue with your washing machine’s heater, and error 09 indicates that unexpected heating has been detected. These issues could be caused by defective heating elements turning on when they shouldn’t, for example during the rinse cycle.

Motor errors

Error 04, 05, 21, 42, 43, and 44

All the above numbers indicate a motor error that can be caused by a number of reasons including damage or corrosion to wiring, or excessive wear. Other components that will need to be checked are the carbon brushes for signs of wearing down, and the tacho connections and panel control board modules.

Sensor errors

Error 06 and 07

This means that there’s an issue with the NTC sensor in your washing machine which may be due to a defective sensor or faulty wiring.

How to reset error codes

In certain cases, you may be able to reset your washing machine to cancel any error codes that are displayed. Take the following steps:

Siemens iQ500 washing machine error codes

If you have a Siemens iQ500 washing machine error codes are slightly different as shown below:

E30 and E80

The cause of these error codes displaying are a blocked drain pipe, drain hose, or drain pump. Alternatively, this could be due to the water outlet hose being connected at a too high level.

E36, E25, and E26

These error codes indicated that the drain pump is blocked.

E60 and E28 The spin cycle has been interrupted as an unbalanced load has been detected and will need to be redistributed.

Start/reload flashing

This is caused by an energy-saving mode that has become active and pressing any button should ensure that the symbol lights up again.

Need to book a repair?

Simply contact your local appliance repair experts to schedule an appointment with a fully qualified and highly trained engineer who’ll quickly diagnose the problem and fix it for you.

Most Common Siemens Washing Machine Error Codes Guide was last modified: January 22nd, 2024 by Mix Repairs
Exit mobile version